Care And Descaling; Descaling - Coffeemaxx Premium Gebrauchsanleitung

Care and Descaling

PlEaSE notE!
❐ The hotplate is very hot after use! Let it cool down first before cleaning it.
❐ Never immerse the device, the cable or the plug in water.
❐ Do not use corrosive or abrasive cleaning agents to clean the device. These could dam-
age the surface.
1. Clean the coffee mill using the cleaning brush.
3. Then close the cover again by pressing down on the cover and adjusting the screw on
the opening for cleaning the coffee mill with the shaft end of the cleaning brush to the
"Closed" symbol
4. Then press the unlocking button on the side of the device and open the filter compart-
ment.
5. Remove the filter cover, take out the permanent filter and dispose of the coffee powder.
6. Clean the filter cover, the permanent filter and the filter compartment insert with hot
water and a little detergent if necessary.
7. Then dry all parts thoroughly and place them in the coffee machine again.
8. If necessary, clean the coffee machine and hotplate with a damp cloth and then with a dry
one.

Descaling

If the water only runs very slowly through the device or the device is louder than usual during
the brewing procedure, you should descale it.
1. Pour the mixture of water and descaling agent into the water reservoir and switch on the
device. Pay attention to the directions for use of the descaling agent in regard to the ratio
of water to descaling agent.
2. Let the mixture run through the machine completely. Repeat this procedure if the water
still runs through slowly.
3. After descaling, let water (without coffee) run through the device at least three times to
flush the lines etc.
4. Please ensure that you have switched on the Mahlen aus function if you want to flush
the device with water or descale it.
01113_DE-GB-FR-NL_V2.indb 26
2. Adjust the screw at the opening for cleaning the coffee mill
with the shaft end of the cleaning brush to the
"Open" symbol
remove any excess coffee powder with the cleaning brush.
.
26
. The cover will open up and you can then
11.02.11 08:18