Commissioning And Making Basic Settings; Brewing Coffee With Freshly Ground Beans - Coffeemaxx Premium Gebrauchsanleitung

Commissioning and making basic settings

1. Place the device on a level, firm and heat-resistant surface.
2. Connect the device to a mains socket that has been properly installed.
3. The preset time "12:00" will appear on the display.
4. Set the time using the Stunde and Minute buttons.

Brewing coffee with freshly ground beans

1. Open the water reservoir cover.
2. Fill the desired amount of water into the water reservoir. On the water level indication,
you can see how many cups of water you have already poured into the water reservoir.
Always fill the water reservoir with at least two up to a maximum of 12 cups of water.
3. Then close the water reservoir cover.
4. Open the filter compartment by pressing the unlocking button on the side of the device.
5. Place the filter compartment insert, the permanent filter and the filter compartment
cover into the filter compartment. Make sure that all parts are placed in correctly as
otherwise the coffee machine will not start the brewing procedure.
6. Close the filter compartment.
7. Fill coffee beans into the grinding mechanism of the coffee machine. Then place the lid of
the grinding mechanism back on.
8. Place the glass pot on the hotplate.
9. Use the 2-12 Tassen button to set the number of cups you would like to brew.
10. You can press the Kaffeestärke button to set the coffee strength. You have a choice of
three levels which are shown to you on the display as follows:
The level mild represents a mild coffee flavour, the level medium represents a medium
coffee flavour and the level strong represents an aromatically strong coffee flavour.
11. Press the An/Aus button to switch on the device. The An/Aus button lights up.
12. As soon as you have pressed the An/Aus button, the grinding procedure begins. After
the grinding procedure, the brewing procedure starts immediately.
13. After the brewing procedure, you can take the glass pot from the hotplate and serve the
coffee.
14. After the brewing procedure, the hotplate remains on for another two hours and then
switches off automatically.
15. If you would like to turn off the coffee machine before the two hours are up, press the
An/Aus button.
16. Clean the device after use as described in the "Care and Descaling" section.
The coffee machine has a non-drip valve. You can also take the glass pot from the
hotplate during the brewing procedure and pour yourself a cup of coffee. But be
careful: You should place the glass pot back on the hotplate within 20 seconds to
prevent the coffee filter from overflowing with water!
01113_DE-GB-FR-NL_V2.indb 23
23
11.02.11 08:18