Herunterladen Inhalt Inhalt Diese Seite drucken

Care And Decalcifying; Decalcifying; Subsequent Ordering - Coffeemaxx Aroma Plus Gebrauchsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Care and decalcifying

ATTENTION!
❐ The heating plate is very hot after use! First allow it to cool off before you clean it.
❐ Never submerge the device, the mains cord or the plug in water.
❐ When cleaning, do not use any scouring or abrasive cleaners. They could damage the surface.
1. Clean the coffee grinder using the cleaning brush.
3. Once you are done, close the cover by pushing it and moving the screw on the opening for
cleaning the coffee grinder to the "Closed" symbol
brush.
4. Then push the release button for the fi lter compartment.
5. Remove the permanent fi lter or the paper fi lter and dispose of the coffee powder.
6. Clean the fi lter compartment insert and the permanent fi lter with warm water and a small
amount of detergent if necessary.
7. Then dry the fi lter compartment insert and the permanent fi lter thoroughly and place it
back in the coffee maker.
8. If necessary, wipe off the coffee maker and heating plate with a damp cloth and a dry cloth.

Decalcifying

You should decalcify the device if the water is circulating very slowly or the device is emitting
more noise than usual during the brewing process.
1. Fill the water tank with a mixture of water and decalcifi er and turn the device on. Consult
the operating instructions for the decalcifi er to determine the correct ratio of water to
decalcifi er.
2. Let the mixture completely circulate through the device. Repeat the process if the water still
circulates slowly.
3. After you have fi nished decalcifying the device, allow water to circulate through the device
at least three times (without coffee) in order to rinse the lines etc.
4. Make sure that you have activated the Mahlen Aus (Grinding off) function when you rinse
the device out with water or decalcify it.

Subsequent ordering

You can order spare parts for your coffee maker in our webshop located at the following address
www.service-shopping.de.
2. Move the screw on the opening for cleaning the coffee grinder
to the "Open" symbol
brush.The cover will open and you can remove any leftover
coffee powder with the cleaning brush.
26
using the pole end of the cleaning
using the pole end of the cleaning

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis