Fitting The Mounting Bracket - Bosch KTS 5 Serie Originalbetriebsanleitung

en 22 | KTS 530 / 540 / 570 (KTS 5 Series) | Initial commissioning
4.3 Connecting via USB
1. Connect the KTS module with the power supply
included with the delivery.
2. Connect the KTS module to the PC/laptop by way of
the USB connection cable.
i
The message "Found new hardware" will appear on
the screen the first time that the KTS modules are
connected using the USB connection cable. This in-
dicates that the USB connection to the KTS modules
has been recognized.
4.4 Module configuration (DDC)
i
The DDC (Diagnostic Device Configuration) software
is used for configuration, activation and the testing
of KTS modules.
1. Start DDC ("Start >> Programs >> Bosch ESI[tronic]
2.0 >> Diagnostic Device Control").
2. Add the KTS module via "New".
i
The further configuration procedure on initial com-
missioning is described in detail in the Online Help.
Pressing <Help> opens the online help. All other im-
portant information on DDC can also be found here.
i
If you have any questions which cannot be answered
by the online help, please contact the ESI[tronic]
service hotline directly.
|
1 689 979 987 2015-09-22
4.5

Fitting the mounting bracket

The mount included with the delivery allows fastening
and loosening the KTS modules on the Bosch trolley
(possible as of production date 03-2006 only).
1. Screw the three oval head screws contained in the
scope of delivery into the Bosch trolley (see fig.4).
Fig. 4: Fitting the mounting bracket
2. Using the sheet-metal screws included with the de-
livery, screw the mount onto the KTS module (holes
for mounting are on the rear of the module).
3. Correct the screw penetration of the oval head
screws on the trolley so that the KTS modules are
solidly and securely seated in position following
installation.
Robert Bosch GmbH