Mounting Instructions - Bosch Rexroth KE310 Bedienungsanleitung

3 609 929 986/1.0 | KE310

4 Mounting Instructions

Unqualified repairs or operations on the hard-
ware or software or the failure to observe the
warnings in these instructions or warnings
placed on the product itself could lead to per-
sonal injury or damage to equipment.
Qualified personnel are:
– Project personnel, familiar with the safety
regulations of automation systems and
electrical engineering.
– Operators, instructed in the use of the
equipment and having knowledge of the
relevant operational parts of this docu-
mentation.
– Commissioning personnel, authorized
to set electric circuits and machines/sys-
tems into operation, ground and mark
them, according to the accepted rules of
safety and current technology.
Repairs and replacement of parts carried out
by the user are his own responsibility. After
repairing or replacing parts, all prescribed
functional and safety checks must be carried
out.
Electric Drives and Controls | Bosch Rexroth AG 15/64
4 Mounting Instructions
The communication unit is to be inserted into
the slots provided in the system boxes or in
the BT300 card rack.
3 Min
Make sure that the communication unit is
completely inserted.
The front knurled bolts must be tightened.
Make sure that the front panel fits tightly to
the BT 300 or system box by tightening the
knurled bolts.
Before the communi-
cation unit is inserted,
the system boxes or
BT300 card rack must
be switched to neutral
and a discharging time
of ≥ 3 minutes must be
taken into account.
Otherwise the time
until the next restart is
approx. 30 seconds.