Demolition; Environmental Information - Cormach CM 646 Handbuch Für Gebrauch Und Wartung

range from 0.5 to 10 bar. The setting can
be modified by pulling the knob to the
OUT position and turning it; after adjusting,
return the knob to the locked position by
pushing it down (fig.25a).
The lubricating flow-rate is adjusted by turn-
ing the screw on the element "L", (fig.25b);
normally the unit is preset at a pressure of
10 Bar, with lubricant having viscosity SAE20,
so that one drop of lubricant is dispensed
every 4 times the bead-breaker is operated
(check through the transparent cup).
DANGER
Before carrying out any maintenance
operation or topping up with lubricant,
disconnect the machine from the com-
pressed air supply line.
Check the lubricant level periodically
through the windows provided and top up
as shown in fig.25c. Top up only with SAE20
non detergent oil to a total quantity of 50 cc.
The FR filter regulator unit is equipped
with an automatic system for drainage of
the condensation water, so in normal con-
ditions it does not require any particular
maintenance. However, the water may be
drained by hand at any time (fig.25d).
Normally it is not necessary to remove
the cups, but this may be necessary after
long periods out of use; if the cup cannot
be removed with the hands only, use the
spanner provided (fig.25e).
Clean with dry cloth. Avoid contact with
solvents.
N.B.: for warnings concerning oil, refer to
the specific section of the machine's opera-
tor manual.
ATTENTION
Keep the work area clean.
Do not clean the machine with compressed
air or jets of water.
When cleaning the area avoid raising dust
as far as possible.
62

DEMOLITION

If the machine is to be scrapped, remove
all electrical, electronic, plastic and metal
parts and dispose of them separately in
accordance with current provisions as
prescribed by law.
ENVIRONMENTAL
INFORMATION
Following disposal procedure shall be
exclusively applied to the machines having
the crossed-out bin symbol on their data
plate .
This product may contain substances that
can be hazardous to the environment or
to human health if it is not disposed of
properly.
We therefore provide you with the following
information to prevent releases of these
substances and to improve the use of na-
tural resources.
This product may contain substances that
can be hazardous to the environment or
to human health if it is not disposed of
properly.
We therefore provide you with the following
information to prevent releases of these
substances and to improve the use of na-
tural resources.
Electrical and electronic equipments
should never be disposed of in the usual
municipal waste but must be separately
collected for their proper treatment.
The crossed-out bin symbol, placed on the
product and in this page, remind you of the
need to dispose properly of the product at
the end of its life.
In this way it is possible to prevent that a
not specific treatment of the substances
CM 646 - CM 646 GT