Safety Regulations - Cormach CM 646 Handbuch Für Gebrauch Und Wartung

SAFETY
REGULATIONS
The equipment is intended for professional
use only.
WARNING
Only one operator may work on the equip-
ment at a time.
WARNING
Failure to observe these instructions and
the relative danger warnings can cause
serious injury to the operator and others.
Do not power up the machine before you
have read and understood all the danger/
warning/attention notices in this manual.
This machine must be used only by quali-
fied and authorised personnel. A qualified
operator is construed as a person who has
read and understood the manufacturer's
instructions, is suitably trained, and is
conversant with safety and adjustment
procedures to be adhered to during opera-
tions. Operators are expressly forbidden
from using the machine under the influence
of alcohol or drugs capable of affecting
physical and mental capacity.
The following conditions are essential:
- The operator must be able to read and
understand all the information in this
manual.
- Make sure you have a thorough knowledge
of the capabilities and characteristics of
this machine.
- Keep unauthorised persons well clear of
the area of operations.
- Make sure that the machine has been
installed in compliance with established
legislation and standards.
- Make sure that all machine operators are
suitable trained, that they are capable of
using the machine correctly and that they
are adequately supervised during their
work.
- Never leave nuts, bolts, tools or other
CM 646 - CM 646 GT
equipment on the machine to avoid the
risk that they could become entrapped
between moving parts during work.
- Do not touch power lines or the inside of
electric motors or other electrical equip-
ment until the power has been discon-
nected and locked out.
- Read this manual carefully and learn how
to use the machine correctly and safely.
- Always keep this user manual in a place
where it can be readily consulted when
working with the machine and consult it
whenever you are in need of confirmation
or explanations.
WARNING
Do not remove or deface the safety
Danger, Warning or Instruction decals.
Replace any missing or illegible Danger,
Warning or Instruction decals. Missing or
damaged decals can be obtained at your
nearest dealer.
- When using and carrying out maintenance
on the machine observe the unified in-
dustrial accident prevention regulations
for high voltage industrial equipment.
- Any unauthorised alterations made to the
machine automatically release the manu-
facturer from any liability in the case of
damage or accidents attributable to such
alterations. Specifically, tampering with or
removing the machine's safety devices is
a breach of the regulations for industrial
accident prevention.
WARNING
When operating or servicing with this
equipment do not wear ties, loose fitting
clothes, necklaces or wristwatches and
any other articles that could become en-
trapped by moving parts. Tie back long
hair or cover with a scarf or a cap.
45