Main Operating Parts Of The Machine - Cormach CM 646 Handbuch Für Gebrauch Und Wartung

or tools not original manufactured.
Figure 7 shows the positions assumed by
the operator during the various stages of
work with the machine.
A Bead breaker
B Tyre demounting and mounting
C Inflation area.
C
WARNING
The tower tilting operation must be carried
out from work position C (fig.7), keeping
your hands well away from all moving parts
of the machine.
WARNING
To stop the machine in an emergency:
- unplug from the electrical supply;
- isolate the air supply network by discon-
necting the shut-off valve (rapid insert).
48
MAIN OPERATING
OF THE MACHINE
Get to know your machine: the best way to
prevent accidents and obtain top perfor-
A mance from the machine is to ensure that
all operators know how the machine works.
Learn the function and location of all
commands.
Carefully check that all the commands on
B
the machine are working properly.
To avoid accidents and injury, the machine
must be installed properly, operated cor-
7
rectly and serviced regularly.
Fig.8a-b-c
1 Locking knob.
2 Vertical slide / swing arm (to position
the mount/demount head)
3 Mount/demount head (for fitting and
removing tyre)
4 Tilt tower
5 Sliding clamp (secures wheel to table
top)
6 Sliding clamp table (rotary platform
supporting the wheel)
7 Tower (4) tilt pedal (2-position pedal
to operate tower tilt)
8 Clamp (5) control pedal (3-position pe-
dal for opening and closing rim clamps)
9 Bead breaker pedal (2-position pedal
to operate the bead breaker (11)
10 Table top (6) pedal (3-position pedal)
• position 0: table top stationary
• depressed (held with foot): clockwise
PARTS
WARNING
A: Up
B. Down
C: Blocked
rotation at speed proportional to
pedal pressure
CM 646 - CM 646 GT