Fitting The Illuminator On The Bracket - Videotec ULISSE IR360 Bedienungsanleitung

7.1.3 Infrared LED illuminators
installation
h Together with the bracket supplied as
standard, the pan & tilt is preset for the
installation of 2 VIDEOTEC UPTIRN LED
infrared illuminators.
h To work properly both illuminators must be
installed together.
7.1.3.1 Fitting the bracket
Position the bracket (03) on the bottom of the
housing as shown in the illustration. Insert the 14mm
screws (01) with their washers (02) into the respective
4 holes (04) and tighten them. Make sure the bracket
is fastened down firmly. Use only the material
supplied with the kit.
04
03
02
01
Fig. 19
Fasten with tightening
h
torque of 4Nm.
16
04
02
7.1.3.2 Fitting the illuminator on the
bracket
Place the fixings of the illuminator (01) on those of
the bracket (02).
Fig. 20
Insert the 16mm screws and washers.
Fig. 21
h Fasten with tightening
torque of 6Nm.
02
01
01
02