Safety Instructions; Symbols And Icons; Symbols On The Device - Parkside PDOS 200 C2 Originalbetriebsanleitung

GB MT
Sound power level (L
measured ............. 93 dB(A); K
Vibration total value
(a
) ................
h
* A break is introduced after 30 minutes of un-
interrupted operating duration until the device
temperature differs 2 K (2 °C) less than room
temperature.
Noise and vibration values have been
determined according to the standards and
regulations mentioned in the declaration of
conformity.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
Warning! The vibration emission
value may differ during actual use
of the power tool from the stated
value depending on the manner in
which the power tool is used.
Try to keep the exposure to vibra-
tions as low as possible. Examples
of measures to reduce vibration
exposure are the wearing of gloves
when using the tool and limiting the
working hours. For this purpose all
parts of the operating cycle have to
be considered (for example, times
when the electric tool is switched
off and times when it is switched on
but running without any load).

Safety Instructions

WARNING!
When using power tools,
24
)
WA
= 3 dB
WA
, K= 1,5 m/s
2.5 m/s
2
observe the following basic
safety measures for the pre-
vention of electric shocks and
2
the risk of injury and fire.
Please read all these instruc-
tions before using the electric
tools and please keep the
safety instructions.

Symbols and icons

Symbols in the manual:
Warning symbols with
information on damage
and injury prevention.
Instruction symbols with infor-
mation on preventing dam-
age.
Connect the machine to the
power supply.
Pull out the mains plug.
Help symbols with informa-
tion on improving tool han-
dling.

Symbols on the device:

Warning!
Risk of injury from the rotat-
ing tool! Keep hands away.