CleanSpace EX Gebrauchsanleitung Seite 12

CleanSpace Respirators
Fit a Neck Supports to CleanSpace PAPR
CleanSpace Respirator comes supplied with two neck
supports:

PAF-1012 NECK SUPPORT SMALL

PAF-1013 NECK SUPPORT LARGE
Select a neck support. PAF-1012 is more suited to smaller
faces while PAF-1013 fits people with larger faces.
The neck support has keyhole openings at each end which
snap over buttons on the respirator case. Place the neck
support in position against the buttons and then press firmly
backwards (towards the respirator) to engage the buttons in
the keyholes.
Fit a mask to CleanSpace PAPR

Examine the mask AirClips. One is open and one is
closed. Find the one that is open. Seen from above it
is on the left hand side.

Locate the left hand blower AirClip. It is on the same
side of the blower as the "POWER" button.

Figure shows the Left hand (OPEN) mask AirClip
Join the AirClips, so that the mask is attached to the blower. See Figures below
Figure A. Join AirClip
IMPORTANT: Check that the mask is the right way up.
The pointed, nose section of the mask must face up, in
the same direction as the keypad. See Figure. Leave the
other mask arm and bellow free until you are fitting the
respirator.
Figure B. Mask on Blower. Note: connection is on left hand side
11
USER INSTRUCTIONS
English