Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. Installing the digital camera
Check the digital camera.
Check the digital camera before loading it in the Case.
Check the battery
Since the LCD monitor is always used to check the image during underwater shooting,
the battery may not last as long as during conventional shooting. Make sure there is
sufficient remaining battery capacity is enough before you start shooting underwater.
Note ：In order to avoid missing photo opportunities due to an exhausted battery, you
should always a fresh fully charged battery before each dive.
Check the remaining number of pictures
Check that the image storage medium has enough room for the number of pictures you
want to take.
Remove the hand strap and lens cap from the digital camera
If a strap or lens cap is attached to the digital camera, it must be removed before loading.
CAUTION
: • If the digital camera is loaded without removing the strap or lens cap, it may
Remove the eyecup from the digital camera's viewfinder
The Case confirms the taken pictures through the pickup
finder.
En
To improve the view of the pickup finder, remove the
eyecup from the viewfinder of the digital camera before
loading the digital camera in the Case.
CAUTION
: Be sure to remove the eyecup before loading the digital camera. Otherwise,
Remove the filter from the digital camera
If a filter is attached to the lens of the digital camera, remove the filter before loading the
digital camera in the Case.
CAUTION
: The digital camera cannot be loaded in the Case while the filter is attached
get caught between the Case lids and cause water leakage.
• When removing the strap and/or lens cap, handle the digital camera
carefully. OLYMPUS IMAGING CORP. shall not be responsible for damage
caused by improper handling.
the rear lid of the Case cannot be closed tightly causing water leakage.
to the lens. Be sure to remove the filter before loading.
E-15
Werbung
Kapitel
Inhaltsverzeichnis
