Install The Digital Camera; Check The Digital Camera; Battery Confirmation; Confirmation Of The Remaining Number Of Pictures To Be Taken - Olympus PT-036 Bedienungsanleitung

3. Install the digital camera.

Check the digital camera.

Check the digital camera before loading it in the Case.

Battery Confirmation

The flash is used very frequently during underwater shooting.
Make sure that you have enough remaining battery power.
EN
Note:
In order to avoid losing shutter chances due to an exhausted battery, you
should always replace a battery with a fully charged battery before each dive.

Confirmation of the Remaining Number of Pictures to be Taken

Confirm that the image storage has a sufficient remaining number of
pictures to be taken.

Remove the hand strap from the digital camera.

When a strap is attached to the digital camera, the hand strap must be
removed.
CAUTION:
• When a digital camera is loaded without removing the strap, the strap may
get caught between the Case lids and may cause water leakage.
• When removing the strap, handle the digital camera with sufficient care.
OLYMPUS IMAGING CORP. shall not be responsible for damage caused
by dropping the camera etc.

Prepare the camera.

Applicable Digital Cameras

This product (PT-036) is designed exclusively for use with the µ 760/
Stylus 760 digital camera.

Turn on the digital camera.

To save battery power, the camera automatically goes into sleep mode
and the monitor turns off if there is no operation when the camera is turned
on. No picture is taken even if the shutter lever is fully pressed in this
mode. Operate the zoom buttons or other buttons to restore the camera
from sleep mode before taking a picture. If the camera is left for 15
minutes, it automatically turns off. Press POWER button to turn the
camera on.
EN 16