Install The Waterproof Port; Attach The Hand Strap - Olympus PT-E01 Bedienungsanleitung

Install the Waterproof Port.

To enable the Case to be used underwater, the separately available Waterproof Port for the
camera lens must be installed on the Case. Align the Waterproof Port with the position
where the camera lens will be when the camera is loaded in the Case.
For more details on attaching the Waterproof Port to the Case, refer to the instruction
manual provided with the Waterproof Port
Apply the provided O-ring grease to the O-ring section of the Waterproof Port and the
Waterproof Port mounting thread on the Case.
Screw the Waterproof Port into the Case by turning it all the way clockwise.

Attach the hand strap.

Attach the hand strap to the Case.
En
CAUTION
: • Be sure to install the hand strap correctly as shown above.
Waterproof Port mount thread
O-ring grease
Hand strap
Hand strap ring
• Two hand strap rings are attached to the side of the Case with the palm grip
one at the top and one at the bottom. Before using the Case, be sure to
attach the ends of the strap to the two hand strap rings.
• OLYMPUS IMAGING CORP. shall bear no responsibility for damage
caused by dropping the Case because of incorrect installation of the hand
strap.
E-9