Insert Silica Gel; Check The Loading Status - Olympus PT-E01 Bedienungsanleitung

Insert silica gel

Before sealing the Case, insert the accessory silica gel bag (for prevention of fogging)
between the bottom right corner of the camera and the Case. Insert the bag with the
shorter side facing inside.
CAUTION
: • Insert the silica gel bag as far as it will go at the specified location and with
the specified orientation. If the orientation is incorrect, the silica gel bag will
catch when the Case is sealed and water will leak into the Case.
• If the bag is only inserted part of the way, it will get caught by the O-ring
when you try to seal the Case and water will leak into the Case
• Once silica gel has been used, its moisture absorption performance will be
impaired. Always change the silica gel when you open or close the Case.

Check the loading status.

Always perform the following final checks before sealing the Case.
• Does the zoom dial operate properly?
• Is the silica gel inserted all the way at the specified position?
• Are the O-rings and the O-ring contact surfaces free of dirt and other foreign matter?
• Are the O-rings installed properly?
• Is the TTL cable connector cap attached properly without loosening?
• Can the camera power be switched ON/OFF?
MENU MENU
MENU
Pay attention to the orientation.
E-20
En