How To Connect The Hot Shoe Cable; How To Attach Or Remove The Camera From The Camera Table - Olympus PT-E01 Bedienungsanleitung

How to connect the hot shoe cable

To perform TTL flash shooting using the Case, connect the hot shoe cable provided with
the Electronic Flash Case between the connector on the Case and the digital camera's
hot shoe.
1
Turn the hot shoe cable connector cap inside the case
counterclockwise to remove it.
2
Insert the connector of the hot shoe cable into the case's
connector and turn the connector screws all the way
clockwise to connect them firmly.
3
Insert the hot shoe on the hot shoe cable into the hot shoe
on the camera.
4
When not using the hot shoe cable, attach the hot shoe
cable cap to the hot shoe cable connector inside the case
and turn the cap all the way clockwise to attach it firmly.
CAUTION
: • Be sure to remove the camera from the case when inserting the connector

How to attach or remove the camera from the camera table

The digital camera is loaded and clamped in the Case by means of the camera table
located inside the front lid of the Case.
1
Turn the camera table clamping lever counterclockwise to
unlock it.
En
2
Slide the camera table out to the front.
3
To load the digital camera into the Case, insert the screw
of the camera table into the tripod screw hole on the
bottom of the digital camera and turn the screw clockwise
to secure it. For details, refer to "Attaching the digital
camera to the camera table" later in this manual.
4
Slide the camera table into the camera table base in the
front lid of the Case.
5
Turn the camera table clamping lever all the way clockwise
to clamp the camera table.
To remove the camera, reverse the above procedure.
of the hot shoe cable into the case's connector.
E-13