Changing A Disc; Use Of Accessories; Cutting / Roughing Discs; Flap Discs For Metal - Parkside PWS 1010 Bedienungs- Und Sicherheitshinweise

©

Changing a disc

½
Always wear protective gloves
when changing cutting or roughing /
grinding discs.
Press the spindle lock button
mounting spindle
7
Fig. A.
Press the spindle lock button
drive.
Release the clamping nut
, Fig. B.
10
Place the roughing, grinding or cutting disc on
to the mounting flange
facing towards the device.
Then replace the clamping nut
raised side facing upwards, on to the mounting
spindle .
7
Press the spindle lock button
drive.
Tighten the clamping nut
spanner .
10
Note: Replace a new disc immediately if it runs
unevenly or vibrates after being exchanged.
After replacing a disc let the device run under
no load for 30 seconds as a safety check.
Look out for unusual noises or generation of
sparks.
Check that all the fastenings are correctly
attached.
Pay attention to see that the arrow showing the
direction of rotation on the cutting or roughing /
grinding discs (including diamond cutting discs)
corresponds with the direction of rotation of the
device (see arrow on the head of the device).
©

Use of accessories

©

Cutting / roughing discs

You can use the following cutting or roughing/
grinding discs with this device:
Dimensions:
Speed:
Circumferential speed: 80 m / sec
only after the
9
has reached a standstill,
to block the
9
using the spanner
6
with its labelled side
8
, with its
6
to block the
9
again with the
6
ø 125 x 22,2 mm
to max. 6 mm thick
(depressed centre)
12.000 rpm
Use / Use of accessories
©

Flap discs for metal

Dimensions:
Speed:
©

Other accessories

You can also use abrasive consumables and tools
complying with the following technical specification:
Spindle thread:
Speed:
Backing plate for grinding discs
Dimensions:
Grinding discs for wood / masonry attached
with hook and eye fixings
Dimensions:
ø 125 mm
min. 12.000 rpm
M14
min. 12.000 rpm
ø 115 mm / 125 mm
ø 115 mm / 125 mm
GB/MT 59