Yamaha RX-V1900 Bedienungsanleitung Seite 96

Using multi-zone configuration
2
Press DPOWER to turn on the selected
zone.
3
Perform the desired operation in the selected
zone (page 92).
y
To turn off the desired zone, press CSTANDBY.
■ Selecting the input source of Zone 2 or
Zone 3
Rotate the CINPUT selector (or set the
operation mode selector to EAMP and then
press one of the input selector buttons (3)).
• Select "TUNER" as the input source to use the FM/AM
tuning features (page 46) in the selected zone.
• Select "DOCK" as the input source to use the iPod
features (page 52) or Bluetooth features (page 54) in
the selected zone.
• Select "USB" as the input source to use the USB
features (page 52) in the selected zone.
Note
The input sources are shared across all zones. You cannot select
the same input source in multiple zones simultaneously.
■ Adjusting the volume level of Zone 2 or
Zone 3
Rotate Q VOLUME (or press I VOLUME +/–) .
y
Press K MUTE on the remote control to mute the sound output
to the selected zone.
Note
When you use the external amplifiers in Zone 2 or Zone 3,
I VOLUME +/– can be used only when "VOLUME" is set to
"VAR" in "ZONE SET" (page 77).
92
En
■ Adjusting the front speaker balance of
Zone 2 or Zone 3
Press ETONE CONTROL repeatedly to select
"BALANCE" and then rotate the NPROGRAM
selector for adjustment.
■ Adjusting the tonal quality of Zone 2 or
Zone 3
Press ETONE CONTROL repeatedly to select
the high-frequency response (TREBLE) or the
low-frequency response (BASS) and then rotate
the NPROGRAM selector for adjustment.
Control range: -10.0 dB to +10.0 dB
■ Setting the sleep timer for Zone 2 or
Zone 3
Use this feature to turn of the desired zone after a certain
amount of time.
Set the operation mode to EAMP and then press
BSLEEP repeatedly to set the amount of time.
The sleep timer setting changes as shown below.
120min.
OFF
90min.
30min. 60min.