Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 246
Troubleshooting

■ Remote control

Problem
The remote control
does not work or
function properly.
The remote control
does not learn new
functions.
100
En
Cause
Wrong distance or angle.
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
The batteries are weak.
The operation mode selector is set
incorrectly.
The control zone setting is incorrect.
The remote control code is not correctly
set.
The remote control ID of the remote
control and this unit do not match.
Even if the remote control code is
correctly set, there are some models that
do not respond to the remote control.
The batteries of this remote control and/or
the other remote control are too weak.
The distance between the two remote
controls is too much or too little.
The signal coding or modulation of the
other remote control is not compatible
with this remote control.
Memory capacity is full.
Remedy
The remote control will function within a maximum
range of 6 m (20 ft) and no more than 30 degrees off-
axis from the front panel.
Reposition this unit.
Replace all batteries.
Set the operation mode selector correctly. When
operating this unit, set it to the E AMP position.
When operating the component selected by the input
selector button, set it to the E SOURCE position.
When operating the TV set in the 3 TV area, set it to
the E TV position.
Select the zone you want to control.
Set the remote control code correctly using
"List of remote control codes" at the end of this
manual.
Try setting another code of the same manufacturer
using "List of remote control codes" at the end of this
manual.
Match the remote control ID of this unit and the
remote control.
Program the necessary functions independently into
the programmable buttons using the Learn feature.
Replace the batteries.
Place the remote controls at the proper distance.
Learning is not possible.
Delete other unnecessary functions to make room for
the new functions.
See
page
27
4
91
83
83
93
85
4
85
89

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis