Advanced Automatic Setup - Yamaha RX-V1900 Bedienungsanleitung

Optimizing the speaker setting for your listening room
y
• If "E-5:NOISY" appears, you can also select "PROCEED" to
ignore the error and carry on the measurement. However, we
recommend that you solve the problem before starting the
measurement.
• If "E-10:INTERNAL ERROR" appears, you can select only
"EXIT".
• For details about each error message, see "AUTO SETUP"
(page 103).
■ If "WARNING" appears
When this unit detects potential problems during the
automatic setup procedure, "WARNING" appears in the
result screen. Check the warning messages to correct your
speaker settings.
y
The adjustments are made even if "WARNING" appears,
however they may not be optimal.
1
Make sure the pointer is pointing at
"WARNING" and then press 8ENTER to
display the detailed information about the
warning.
The number on the right of "WARNING" indicates
the number of warning messages.
AUTO SETUP
.
WARNING (2)
RESULT
MLT :
SP
DIST:
LVL : -10.0/+5.0dB
>SET
[ ]/[ ]:
[ENTER]:
2
Press 8l / h repeatedly to toggle between
the warning displays.
WARNING
W-1:OUT OF PHASE
Reverse channel
FL
CENTER
---
SL
SBL
[p]/[[]:
[ENTER]:
y
• For details about each warning message, see "AUTO
SETUP" (page 103).
• When the corresponding warning message is not
applicable to a speaker, "– – –" is displayed instead.
• If "SWFR:TOO LOW" or "SWFR:TOO HIGH" appears
under "W-3:LEVEL ERROR", adjust the volume level of
the subwoofer.
3
Press 8ENTER to return to the top result
display.
32
En
1
: 5/4/0.1
14.0/17.0ft
CANCEL
Up/Down
Detail
---
PR
---
---
Select
Return

Advanced automatic setup

If you have done all the preparations necessary, follow the
procedure below to optimize the setup of this unit for
multiple listening positions.
1
Place the optimizer microphone at the first
listening position.
The following illustration shows how to place the
optimizer microphone in order to optimize the setup
of this unit for seven listening positions for example.
1
2
3
1/2/3/4/5/6/7: Listening positions
2
Press 8k / n repeatedly to select "MULTI
MEASURE" and then press 8l / h
repeatedly to set the number of the listening
position you want to make the measurement
at.
Choices: 1 (default), 2, 3, 4, 5, 6, 7, 8
AUTO SETUP
SETUP;;;;;;;;;AUTO
.
MULTI MEASURE;;;;7
START
[ ]/[ ]:
[p]/[[]:
3
Press 8k / n repeatedly to select "START"
and then press 8ENTER.
AUTO SETUP
SETUP;;;;;;;;;AUTO
MULTI MEASURE;;;;7
.
START
[ ]/[ ]:
[ENTER]:
7
6
4 5
Up/Down
Select
Up/Down
Start