Disposal And Recycling - Scheppach CSE2500 Originalbetriebsanleitung

The connection complies with the relevant VDE and
DIN regulations.
The customer-side mains supply and the used
extension line must meet these regulations.
Important information
In the event of an overloading the motor will switch
itself off. After a cool-down period (time varies) the
motor can be switched back on again.
Defective Electric Connection Lines
Often, insulation damages occur on electrical
connection lines.
Causes are:
• Drag marks if connection lines are led through
window or door clearances.
• Kinks due to improper attachment or routing of the
connection line.
• Cuts caused by running over the connection line.
• Insulation damages caused by pulling the
connection line out of the wall socket.
• Fissures caused by the ageing of the insulation.
Such defective electric connection lines must not
be used and are hazardous due to the insulation
damages.
Regularly check the electrical connection lines for
damages. Please make sure that the connection
lines are disconnected from the mains supply during
the check.
Electrical connection lines must comply with
the relevant VDE and DIN regulations. Only use
connection lines labelled with H05VV-F. The labelling
of the connection cable with the type specification
is required.
AC motor
• The mains voltage must be 230 - 240 V~
• Extension leads up to 25 m in length must have a
cross-section of 1.5 mm2. Extension leads whose
length is over 25 m must have a cross-section of
at least 2.5 mm2.
Connections and repairs of electrical equipment may
only be carried out by an electrician.
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Machine data - type plate

13. Disposal and recycling

The equipment is supplied in packaging to preven it
from being damaged in transit. The raw materials in this
packaging can be reused or recycled. The equipment
and its accessories are made of various types of material,
such as metal and plastic. Defective components must be
disposed of as special waste. Ask your dealer or your local
council.
Old devices must not be disposed of with household waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE). This product must
be disposed of at a designated collection point. This
can occur, for example, by handing it in at an
authorised collecting point for the recycling of waste
electrical and electronic equipment. Improper
handling of waste equipment may have negative
consequences for the environment and human
health due to potentially hazardous substances that
are often contained in electrical and electronic
equipment. By properly disposing of this product, you
are also contributing to the effective use of natural
resources. You can obtain information on collection
points for waste equipment from your municipal
administration, public waste disposal authority, an
authorised body for the disposal of waste electrical
and electronic equipment or your waste disposal
company.
GB 33