Eliwell ICPlus 902/A Bedienungsanleitung Seite 19

PAR. DESCRIPTION
Temperature control setpoint SP1. The SEtpoint is visible from the
SP1
machine status menu and not from the programming menu.
REGULATOR 1 (folder 'rE1')
This sets the controller 1 operating mode.
HC1
H (0) = Hot; C (1) = Cold.
OS1 Temperature value to be added to SP1 if reduced set enabled
Controller 1 activation differential.
dF1 The utility stops on reaching the SP1 value (as indicated by control probe) and
restarts at a temperature value equal to T=SP1+dF1 relative to HC1.
HS1 Maximum value assignable to setpoint SP1.
LS1 Minimum value assignable to setpoint SP1.
Maximum temperature alarm on controller 1.
HA1
(See 'Max/Min temperature alarms')
Minimum temperature alarm on controller 1.
LA1
(See 'Max/Min temperature alarms')
Switch-on delay. The indicated time must elapse between the request for
dn1
activation of the controller 1 relay and switch-on. 0 = not active.
Delay time after switching off. The indicated time must elapse between
dO1
deactivation of the controller 1 relay and the next switch-on. 0 = not active.
Delay between switch-ons. The indicated time must elapse between two
di1
consecutive switch-ons of regulator 1. 0 = not active.
Switch-off delay. The indicated time must elapse between the request for
dE1
deactivation of the controller 1 relay and switch-off. 0 = not active.
PARAMETERS TABLE
19
MODEL RANGE VALUE M.U. LEVEL
ALL LS1...HS1
ALL H/C
ALL -30.0...30.0
ALL 0.0...30.0
NTC/PTC
LS1...HdL
PT100-Tc
NTC/PTC
LdL...HS1
PT100-Tc
-199.9
NTC/PTC LA1...150.0
PT100-Tc
LA1...1999
NTC/PTC
-150.0...HA1
PT100-Tc
-328...HA1 -199.9
ALL 0...250
ALL 0...250
ALL 0...250
ALL 0...250
0,0 °C/°F
H flag Inst
0.0 °C/°F Inst
1.0 °C/°F User/Inst
140.0
°C/°F User/Inst
1350
-50.0
°C/°F User/Inst
140.0
°C/°F User/Inst
1350
-50.0
°C/°F User/Inst
0 secs Inst
0 min Inst
0 min Inst
0 secs Inst