Eliwell ICPlus 902/A Bedienungsanleitung Seite 12

The resources are organized into 2 menus which are accessed as follows:
• 'Machine Status' menu: press and release the
• 'Programming' menu: hold down the
Either do not press any keys for 15 seconds (timeout) or press the
screen.
Password 'PA1': used to access User parameters. The password is not enabled by default (PS1=0).
To enable it (PS1≠0): press and hold
PS1, press to display the value, modify it using
order to access the User parameters.
Password 'PA2': used to access Installer parameters. The password is enabled by default (PS2=15).
To modify it (PS2≠15): press and hold
label PA2, press , set the value to '15' using
diS and press to enter. Scroll through the parameters using
modify it using and
The visibility of 'PA2' is as follows:
1) PA1 and PA2 ≠ 0: Press and hold
access the User parameters (PA1) or the Installer parameters (PA2).
2) Otherwise: The password PA2 is amongst the level1 parameters. If enabled, it will be required when accessing the Installer
parameters; to enter it, proceed as instructed for password PA1.
If the value entered is incorrect, the label PA1/PA2 will be displayed again and the procedure will need to be repeated.
ACCESSING AND USING THE MENUs
key.
key for 5 seconds.
for longer than 5 seconds, scroll through the parameters using
for longer than 5 seconds, scroll through the parameters using
and
, then save it by pressing
for longer than 5 seconds to display PA1 and PA2. It will then be possible to decide whether to
key once, to confirm the last value displayed and return to the previous
PASSWORD
and , then save it by pressing
, then confirm using
and until you see the label PS2, press
or .
12
and until you see the label
or . If enabled, it will be required in
and
.Scroll through the folders until you find the label
until you see the
to display the value,