Troubleshooting - Reloop RMP-1 SCRATCH MK2 B Bedienungsanleitung

Cue Point memories. when pressing the button of a sample bank without previously having acti-
vated the Memory button or the sample button, the Player returns while in Play mode as well as
in Pause mode to the beginning of the respective sample. This function is only available for CDs
of samples or with sample banks that are illuminated in red.
nOTes:
• If you wish to lastingly save the set Cue Points / Samples, press the Memory button -16- for
two seconds. The display reads „Saving". This means that the Cue Points / Samples of the
CD's own sample will be maintained even after switching the device off. Saving the four Cue
Points / Samples is possible for up to 500 CDs. To prompt the saved Cue Points / Samples of a
CD again, press the Memory button -16- BEFOrE inserting the CD. The display reads „recall".
Now insert the CD and the previously stored Cue Points/Samples are automatically loaded.
The respective storage banks flash red and are ready for play.
• To completely delete the Cue Point / Sample Bank memory, first switch off the device with
the ON/OFF switch -31-. Then turn the Search wheel -5- counter-clockwise until the point of
resistance and hold it in this position. Switch the device on with the ON/OFF switch. release
the Search wheel again as soon as the display reads „Clear all".
END OF OPErATION
Before turning off the device via the ON/OFF button, please make sure that there is no CD left inside
the player. Also make sure that the CD tray is closed. If this is not the case, turn the player on and
then close the tray via the Open/Close button -19-.

TrOUBlEShOOTINg

If your Reloop RMP-1 scratch is experiencing any difficulties please check the following table for
malfunction symptoms and take the corrective measures proposed in the table.
symptoms
• No power when activating the power ON/OFF switch.
• The CD replay does not start.
• No sound.
• CD skips.
• Humming sound.
Possible Cause
• Poor mains plug connection.
• The CD is upside down in the tray or is soiled.
• Output cable is wrong or not correctly connected, wrong amplifier or mixing console operation.
• The CD player is contiuously exposed to vibrations and shocks for more than 10 seconds.
• Loose cable connections.
Remedy
• Check mains plug connection.
• Place CD in the tray with label facing up; clean your CD.
• Check connections of output cables and settings on amplifier or mixing console.
• Install the equipment ar another location.
• Check sound plugs.
23