Reloop RMP-1 SCRATCH MK2 B Bedienungsanleitung Seite 20

J) Dot Matrix Information Display
Indicates the name of the folder, artist and title while playing an MP3 CD with ID3 tag or an audio CD
with CD text. To change between the name of a folder, artist and track of an MP3-CD, press the Track
Wheel -4-. While in the pre-set menu, the necessary settings are made in the Dot Matrix Information
Display.
K) CUe
Indicates if the player is in Cue mode (the display reads „Cue").
l) Pause
Indicates if the player is in Pause mode (the display reads „||").
M) Direction
Indicates if the player is in Forward, Reverse or Stop mode.
N) CD/MP3 Mode
Indicates if an audio CD (the display reads „CD") or an MP3-CD (the display reads „MP3") is playing.
O) Auto-Cue status
Indicates if Auto-Cue is activated (the display reads „Auto Cue"). To de-/activate Auto-Cue press
and hold the Single/Continue button -8- for two seconds.
P) Play Mode
Indicates if the player is in Single mode (the display reads „Single") or in Continue mode (nothing
on display).
Q) Reloop
Indicates if the player has stored a loop which can be prompted with the Reloop button
12. loop IN button
Activate the Loop IN button -12- to set the start point of a loop (endless loop) and also to set a cur-
rent Cue Point.
13. loop OUT button
Activate the Loop Out button -13- to set the end point of a loop (endless loop). If the Loop IN button
was previously activated, the player goes into the Loop mode (seamless loop) - the display reads
„Reloop". To exit the loop, press the Loop OUT button again.
>> For more information about loops go to the chapter entitled „Sampling".
14. reloop button
Press the Reloop button -14- for the player to return to the last loop that was played. To exit the loop,
press the Loop OUT button again.
>> For more information about loops go to the chapter entitled „Sampling".
15. CUE/Sample Banks 1-4
When in Play mode, the Cue/Sample banks 1 to 4 -15- can be used as Hot Cue buttons. Once the
Sampler mode has been activated by using the Sampler button -17- the player will play samples from
the banks simultaneously with the playback. For every bank, a 5-second sample can be saved and
played back. Press one of the respective Bank buttons 1 to 4 to trigger the previously stored Cue
Points or samples.
>> For more information about loops go to the chapter entitled „Sampling".
16. Memory button
Use the Memory button -16- to assign and store loops in the four sample banks. After creating a Loop
with the help of the Loop IN and Loop OUT buttons, press the Memory button -16-. The Memory LED
goes on. Then select one of the four sample banks to store the Loop on the very same. The respec-
tive sample bank goes on. The Memory LED goes off. Repeat this process to replace the respective
sample or to record a new one.
>> This Memory function also makes it possible to lastingly store Cue Points and samples of up to
500 CDs. read more information in the chapter entitled „Sampling".
20