Reloop RMP-1 SCRATCH MK2 B Bedienungsanleitung Seite 18

5. Search wheel
Turn the Search Wheel -5- to advance the track clockwise and counterclockwise. The wheel features
four different search speeds. The faster the wheel is turned in either direction, the faster you will
advance. While in Pause mode, frame-search the track passages. The current frame (=1/75 minute)
is constantly repeated.
6. Folder Search buttons
If an MP3-CD is divided into folders, change directly into these folders using the Folder Search but-
tons -6-.
7. Time button
Use the Time button to change between three time modes:
I) Time passed of a track (no separate indication on display)
II) Remaining time of a track (display reads „Remain")
III) Remaining time of entire CD (display reads „Total Remain")
NOTE: Press the Time button -7- and the Track wheel -4- simultaneously to access the pre-set
menu. Turn the Track wheel to select a desired menu item. Press to access the respective sub-me-
nu. To exit the pre-set menu, press the Time button -7- again. Select from the following menu items:
1. Version: Firmware information
2. Sleep: Set the stand-by time from 0 - 120 min. (0 min. = inactive)
3. Stop Time: Set the time interval from 0.5 - 20 sec. when the track will pass the display again
4. run Time: Set the running speed of the tracks showing on the display from 20 mSec. - 1000 mSec.
5. Sensitivity: adjust the jog wheel's sensitivity from -20 to +20.
6. Defaults: Yes = reset factory settings; Exit = Exit without resetting to factory settings;
7. Save: Yes = Save the settings made; Exit = Exit the menu without saving the settings made;
8. Single / Continue button
Use the Single/Continue button -8- to select two different play modes:
I) Single
II) Continue
NOTE: Deactivate the „Auto-Cue" mode by pressing and holding the Single/Continue button for
two seconds. Press the same buttons slightly longer to activate them again.
>> For more information regarding the „Auto-Cue" mode go to item 2.
9. Bank Programme button
Use the Bank Programme function -9- to play a sequence of loops saved on the banks. If loops have
been saved on the sample banks, activate the Bank Programme function with the Bank-P button -9-.
>> For details on how to save loops, go to the chapter entitled „Sampling". The display indicates
„Bank P01". By pressing the Cue/Sample buttons 1 to 4 -15- in any sequence, an individualised
sequence of up to 12 samples can be programmed.
NOTE: There are two different play modes: An Endless mode and a One Shot mode. The Endless
mode is activated by pressing the Sampler button - 17 – once; the sampler lED is continually il-
luminated. In Endless mode the programmed sequence is played endlessly. The One Shot mode is
activated by pressing the Sampler button - 17 - again. The sampler lED flashes. In One Shot mode
the programmed sequence is played once only. To play the above programmed sequence, press
the Sampler button -17- (once for Endless mode / twice for One Shot mode) and press the Bank P.
button -9- to start play. To stop play, press the Sampler button -17- once again until the lED is off.
18
The current title is played; the player then goes into Pause mode.
The entire CD will be played until you stop it or power is interrupted.