Installing Batteries In The Remote Control; Using The Remote Control - Yamaha MCR-E320 Bedienungsanleitung

Controls and functions

Installing batteries in the remote control

Press
1
Press on the battery cover and open the
cover.
2
Insert the two supplied batteries (AA, R06,
UM-3) into the battery compartment.
Insert the batteries according to the polarity markings
(+ and –).
3
Close the battery cover.
To replace batteries
Change both batteries when the operation range of
the remote control decreases.
Notes
• Do not use an old battery together with a new one.
• Do not use different types of batteries (for example, alkaline
and manganese) together. Each type of battery has its own
characteristics even if they are similar in shape.
• If the batteries run out, immediately remove them from the
remote control to prevent an explosion or acid leak.
• If a battery starts leaking, dispose of it immediately. Be careful
not to let the leaking battery acid touch your skin or clothing.
• Before inserting new batteries, wipe the compartment clean.
• Dispose of batteries according to your regional regulations.
8
En

Using the remote control

30˚
Use the remote control within 6 m (20 feet) of this
unit and point it toward the remote control
sensor (see page 3).
Notes
• Do not spill liquid on the remote control.
• Do not drop the remote control.
• Do not leave the remote control in the following places:
– hot or humid places such as bathroom or near a heater
– extremely cold places
– dusty places
Within 6 m
(20 feet)
30˚