Programmed Playback (Program) - Yamaha MCR-E320 Bedienungsanleitung

Basic playback operations for discs and USB devices
Programmed playback
(PROGRAM)
You can customize the playback order up to 40 tracks
stored in a disc/USB device. The example below uses a
disc.
STANDBY/ON
1 2
Number
5 6
keys
9 0
PROG
PROG
s
TIME/INFO
1
While a disc is loaded, press PROG.
CD/Program
P01
T000
Flashes
2
Use the number keys to enter the track
number you want to program.
CD/Program
P01 T008
Time of the programmed track
3
Repeat step 2 until you finish programing all
desired tracks.
Notes
• For MP3 or WMA files recorded on a disc/USB device, the
total time of the programmed files is not displayed.
• For MP3 or WMA files recorded on a disc/USB device, the
number assigned to each file corresponds to the file sequence
in the disc/USB device, not in the individual folders.
22
En
OPEN/CLOSE
3 4
7 8
INDEX DIMMER
FREQ/TEXT
A B
REPEAT
PTY SEEK
MODE START
RANDOM
h
b a
/
DISPLAY SLEEP
01:23
4
To finish track programming, press PROG.
CD/Program
P09 TTL
Total number of
programmed tracks
5
To start program play, press h.
To check or correct the programmed
tracks
1
In the stop mode, press PROG.
The program display appears in the front panel
display.
2
Press b / a to check the program order.
3
To correct a programmed track, display the
track number (refer to step 2 on the left side)
to be corrected, and use the number key(s) to
enter the track number to be newly
programmed.
4
To finish checking or correcting the
programmed tracks, press PROG.
To cancel program
Press s in the stop mode.
Note
If you open the disc tray or set this unit to the standby mode, the
programmed order is automatically cleared.
60:59
Total time of
programmed tracks