Connecting A Subwoofer - Yamaha MCR-E320 Bedienungsanleitung

Connecting speakers
1
Remove approximately 10 mm (3/8 in) of
insulation from the end of each speaker
cable and then twist the exposed wires of the
cable together to prevent short circuits.
10 mm (3/8 in)
2
Unscrew the knob.
3
Insert the bare wire into the terminal.
4
Tighten the knob to secure the wire.
Connecting banana plugs
If you remove the caps from the terminals, you can also
use banana plugs to connect your speakers to this unit.
Tighten the each terminal knob, and insert the
banana plug connector into the end of the
corresponding terminal.
10
En
Red: positive (+)
Black: negative (–)
Red: positive (+)
Black: negative (–)
Red: positive (+)
Black: negative (–)

Connecting a subwoofer

Connecting a subwoofer is optional. The low frequency
signals of the front left and right channels are downmixed
at the SUBWOOFER OUT jack of this unit.
Connect the SUBWOOFER OUT jack on this unit
to the INPUT jack on your subwoofer using a
subwoofer cable.
SPEAKERS
L
R
INPUT
CAUTION
Do not connect the power cables of this unit and the subwoofer
until all cable connections are completed.
DIGITAL
OPTICAL
SUB WOOFER
OUT
OUT
Subwoofer cable
INPUT
Subwoofer