Program Settings - Nibe HPAC S40 Installateurhandbuch

POWER CONNECTION
HPAC S40 is factory fitted with power cable and plug
(W101, length 3 metres).
HPAC S40 | GB

Program settings

Program setting of HPAC S40 can be performed via the
start guide or directly in the menu system in your com-
patible heat pump.
Caution
See also the Installer Manual for your compat-
ible heat pump.
START GUIDE
The start guide appears at first start-up after heat pump
installation, but can also be found in menu 7.7.
MENU SYSTEM
Settings can also be made in the menu system.
MENU 7.2.1 - ADD/REMOVE ACCESSORIES
Add or remove accessories here.
Select: "HPAC".
MENU 1.1 - TEMPERATURE
Menu 1.1 Temperature
You make temperature settings for your installation here.
MENU 1.1.2 - COOLING
Set the temperature (with room sensor installed
and activated):
Setting range: 5 – 35°C
The value in the display appears as a temperature in °C
if the climate system is controlled by a room sensor.
Caution
A slow climate system, such as underfloor
heating, may be unsuitable for controlling with
room sensors.
Setting the temperature (without room sensors
activated):
Setting range: -10 to +10
The display shows the set value for heating/cooling
(curve offset). To increase or reduce the indoor temper-
ature, increase or reduce the value in the display.
The number of steps the value has to be changed in
order to achieve a one degree change to the indoor
temperature depends on the climate system. One step
is usually enough, but in some cases several steps may
be required.
Setting the desired value. The new value is shown on
the right-hand side of the symbol on home screen
cooling.
29