Nibe HPAC S40 Installateurhandbuch Seite 30

TIP
Wait 24 hours before making a new setting,
so that the room temperature has time to sta-
bilise.
If it is cold outdoors and the room temperature
is too low, increase the curve slope in menu
1.30.1 by one increment.
If it is cold outdoors and the room temperature
is too high, reduce the curve slope in menu
1.30.1 by one increment.
If it is warm outdoors and the room temperat-
ure is too low, increase the value in menu 1.1.1
by one increment.
If it is warm outdoors and the room temperat-
ure is too high, reduce the value in menu 1.1.1
by one increment.
MENU 1.3 - ROOM SENSOR SETTINGS
Factor system cooling
Setting range: 0,0 - 6,0
Activate room sensors to control the room temperature
here.
You can connect up to four room sensors to each cli-
mate system, and you can give each sensor a unique
name.
The sensor in each climate system that is furthest from
the set temperature takes control; the compatible
product tries to keep the temperature down in the room
whose sensor is furthest from the set value.
Caution
A slow heating system such as underfloor
heating may be inappropriate for controlling
with room sensors.
Factor system
You can also set a factor that determines by how much
the difference between the desired and current room
temperature will affect the supply temperature to the
climate system. A higher value gives a greater and faster
change in the cooling curve's set offset.
Caution
Too high a set value for "factor system" can
result in an uneven room temperature.
30
MENU 1.30.7 - OWN CURVE
Own curve, cooling
Caution
Curve 0 must be selected for own curve to
apply.
You can create your own cooling curve here, if there are
special requirements, by setting the desired supply
temperatures for different outdoor temperatures.
Supply temp
Setting range: -5 – 40 °C
Depending on which accessory is used the setting range
can vary.
MENU 4.2.3 - SG READY
Affect cooling
With low price mode of "SG Ready" and cooling opera-
tion the indoor temperature is not affected.
With over capacity mode on "SG Ready" and cooling
operation, the parallel offset for the indoor temperature
is reduced by "-1". If a room sensor is installed and activ-
ated, the desired room temperature is instead reduced
by 1 °C.
MENU 4.2.5 - SMART PRICE ADAPTION™
Affect cooling
Alternative: on/off
Degree of effect
Setting range: 1 - 10
This function can only be used if your electricity supplier
supports Smart price adaption, if you have an hourly
tariff agreement and an active myUplink account.
Smart price adaption™ moves the heat pump's consump-
tion over 24 hours to periods with the cheapest electri-
city tariff, which gives savings for hourly rate based
electricity contracts. The function is based on hourly
rates for the next 24 hours being retrieved via myUplink
and therefore an internet connection and an account for
myUplink are required.
You can choose which parts of the installation are to be
affected by the electricity price and to what extent; the
higher value you select, the greater the effect the elec-
tricity price has.
NOTE
A value that is set high may result in increased
savings, but may also affect the comfort.
HPAC S40 | GB