Select The User Memory; Start The Blood Pressure Measurement - Beurer BM 93 Cardio Gebrauchsanleitung

• You can take the measurement while sitting or lying. Always make sure that the cuff is at heart
level.
• To take your blood pressure, make sure you are sitting comfortably with your arms and back
leaning on something. Do not cross your legs. Place your feet flat on the ground.
• To avoid falsifying the measurement, it is important to remain still during the measurement and
not to speak.
• When taking the measurement, please keep the device lying flat (horizontally) on the table.
Wait for at least 1 minute before taking another measurement.

7.3 Select the user memory

The device has two user memories. Each user memory can store up to 60 measured values. Once
all memory spaces in a user memory have been used, the oldest measured values are replaced
by the most recent.
• Briefly press the memory button M. The last set user is displayed. Press and hold the memory
button M for 5 seconds to switch between the user memories.

7.4 Start the blood pressure measurement

1. As described above, attach the cuff and adopt the correct posture.
2. Press the START/STOP button
mode. You can now switch between the user memory (
for 3 seconds.Press the START/STOP button
The blood pressure symbol appears on the display and the cuff inflates. The heart symbol begins
to flash as soon as the device detects a pulse.
You can cancel the blood pressure measurement at any time by pressing the START/STOP
button again. Cancelled blood pressure measurements are not stored.
3. The results are displayed on the display as soon as the blood pressure measurement is complete.
4. To switch off the device, press the START/STOP button
switches off automatically.
to turn on the device. The device is now in ECG measurement
again to start the blood pressure measurement.
46
/ ) by press and hold the button M
or wait for 2 minutes until the device-