(NC) contact for reopening during closing.
Input for safety devices such as photocells, sensitive safety-e-
dges and other devices that are compliant with EN 12978
standards.
During closing, opening this contact triggers an inversion of
movement until the door is completely open.
Signaling devices
PROGRAMMING DEVICE -
Preparing for programming
Manually hook up the door to the skid.
Power up the operator. After emitting a sound signal, the
control board is ready for programming.
Remove the transparent panel to access the programming
keys.
Memorizing (function 5) must always be the last phase of programming, otherwise the settings will not
be saved.
In the case of errors, cut off and the power up again the mains power and reprogram.
Description of keys
Transmitter
memorizing
key
Menu access and
save changes key
Some functions must be set so that the operator can work, others, on the other hand, are optional
If a device is connected, remove the bridge
Flashing light (contact rated for: 24 V - 25 W max).
It fl ashes during opening and closing.
Display for programming and monitoring the
operator's operation
Legend of symbols
Menu adjusting
and browsing key
Menu adjusting
and browsing key
L = normal
operation
F = obstacle
detection
H = Encoder error
A = Active
photocell