Made For Iphone Mfi; Battery Life; Replace The Battery - Cochlear Baha 5 SuperPower Bedienungsanleitung

Turn off the sound processor by
1
disconnecting the battery.
Press and hold the lower button and connect
2
the battery at the same time.
To deactivate flight mode, turn the sound
processor off and back on again by disconnecting
and connecting the battery.

Made for iPhone MFi

Your sound processor is a Made for iPhone (MFi)
hearing device. This allows you to control your
sound processor and stream audio directly from
iPhone, iPad or iPod touch. For full compatibility
details and more information visit www.cochlear.
com.
Talk on the phone
See figure
For best results, use a Cochlear Wireless Phone
Clip or stream the conversation directly from
your iPhone. When using a normal handheld
phone, place the receiver near the microphone
inlet of your sound processor instead of near
your ear. Ensure the receiver does not touch the
sound processor as this may result in feedback.
Batteries
There are two different batteries for the Baha 5
SuperPower: the Standard Rechargeable Battery
Module and the Compact Rechargeable Battery
Module. Ask your hearing care professional for
more information about the choice of battery.

Battery life

Batteries should be replaced as needed just as
you would with any other electronic device.
Battery life varies according to the programs used
each day, the sound environment use of wireless
accessories, and the size of battery.
The rechargeable battery's lifespan is at least 365
charge cycles. A completely empty rechargeable
battery will take approximately four hours to
recharge.
Rechargeable batteries may take longer to fully
recharge with age. To get the longest life from the
rechargeable batteries, always recharge before use.
When there is approximately one hour of battery
power remaining, you will hear an audio indicator
comprising of two sets of four short beeps, and
the visual indicator will flash repeatedly. At this
time you may experience low amplification. If
the battery runs down completely, the sound
processor will beep and then stop working.

Replace the battery

Remove the battery
Twist the battery module to remove it from the
processing unit.
Attach the battery
7
Align the battery module to the processor socket
to fit the parts together. Twist the battery module
as shown to attach the parts. The processor will
turn on automatically.
Lock/Unlock the battery (tamper-proof)
See figure
1 To increase tamper resistance, push the lock to
the far left with your battery cover locking tool
to lock the battery module.
2 Push the lock to the far right to unlock the
battery module.
Charge battery modules
1 Angle and fit the rechargeable battery module
into a socket on the Cochlear Nucleus
Charger.
Twist clockwise to connect.
2
Connect the battery charger to the power
3
adaptor and plug into mains power.
See figure 2
See figure 2
9
See figure
English
10
Battery
®
7