RIB R60 Handbuch Seite 17

ACCESSORIES -
K
S2/R2
Automatic travel and timing code learning system
Automatic closure
Pre-blinking
Slow speed in close position approach
Electronic adjustment of the force
Radio command - step by step or automatic
Single command - step by step or automatic
Directional open and close commands (with timer control)
Electric lock release operation
Stop command
Connectable to encoder to detect obstacle - photocells - strips - blinker
- key selector - buzzer - electric lock
E
XPANDER CARD
!! FEED THE EXP CARD IN WHEN POWER IS NOT SUPPLIED !!
- PEDESTRIAN OPENING COMMAND
- AUTOMATIC PEDESTRIAN CLOSING
- MANAGEMENT OF THE SAFETY EDGE
- 24VAC ACCESSORIES FEEDING
- MANAGEMENT OF THE TRAFFIC LIGHT CONTR
- MANAGEMENT OF THE COURTESY LIGHT
- CLOSING COMMAND AFTER
PHOTOCELLS*
For the connections and the technical data of the optional equipments follow the relevant
handbooks.
code ABKS160
PASSING THROUGH THE
code ACG5470
R
ADIO TRANSMITTER SUN
SUN 2CH code ACG6052
SUN CLONE 2CH code ACG6056
C
ODE LEARNIG SYSTEM RADIORECEIVERS
RX433/A super eterodyne and coupling
RX433/A super eterodyne and terminal board
RX433/A 2CH super eterodyne, 2 channel and coupling code ACG5051
RX433/A 2CH super eterodyne, 2 channel and terminal board
S
PARK
In order to make the systems mentioned above give the best
performances, you need to install an antenna tuned on the frequency
of the radio receiver installed.
N.B. Pay attention to not let the central wire of the cable to came
Into contact with the external copper sheath, since this would
prevent the antenna from working.
Install the antenna vertically and in such a way the remote control can
reach it.
SPARK BLINKER WITH IN-BUILT INTERMITTENT CARD
LATERAL SUPPORT
SPARK ANTENNA 91
SPARK ANTENNA 433
17
17
SUN 4CH code ACG6054
SUN CLONE 4CH code ACG6058
code ACG5055
code ACG5056
code ACG5052
code ACG7059
code ACG7042
code ACG5454
code ACG5452
G
B