Changing Measurement Mode; Continuous Measurement Mode; Single Measurement Mode; Error, Faults & Troubleshooting - Parkside PLEM 20 A2 Bedienungs- Und Sicherheitshinweise

in the middle of the display. Now, the laser beam will be
turned off.

Changing measurement mode

Continuous measurement mode

Under single measurement mode, press and hold the
MEAS button
urement mode.
Laser icon flashes in continuous measurement mode

Single measurement mode

Under continuous measurement mode, press and hold the
MEAS button
mode.
Laser icon stays on in single measurement mode.
Error, faults & troubleshooting
Faults Cause
----- Calculation error
301 Operating temperature
too low or too high
30 GB/IE
for 3 seconds to enter continuous meas-
4
for 3 seconds to enter single measurement
4
Solution
Pay attention to the
correct operating
measuring range.
Pay attention to the
correct operating
temperature range
(0 °–40 °C).