Selecting The Unit Of Length; Measuring Lengths - Parkside PLEM 20 A2 Bedienungs- Und Sicherheitshinweise

To Switch Measuring Reference point: Press the reference /
unit button
side of the product to its bottom side or vice versa.

Selecting the unit of length

1. Press and hold the REF/UNIT button
3 seconds.
2. The unit will change on the display.
3. Repeat the step 1 until the desired unit appears on the
display.
Note: Following units of length are available:
m meter
in inch
ft foot / feet
' " feet / inches

Measuring lengths

Briefly press the MEAS button
beam.Once the laser is switched on, this is indicated on
the top left corner of the display by the icon
Note: If laser beam is already activated, the above men-
tioned step can be skipped.
Now aim the laser at the target point. Briefly press the
MEAS button
the measured value will be shown on the bottom line of the
display and the laser beam will be turned off.
If needed to measure another distance, repeat above steps.
Newly measured value will be shown on the bottom line of
the display and the previous measured value will be shown
to change measurement base from the top
5
again. If the measurement is successful
4
for more than
5
again to activate the laser
4
.
7
GB/IE 29