Parts Counting - OHAUS PX Series Bedienungsanleitung

The PX balance can be operated in 6 application modes by long pressing the
Before using any application, be sure the balance has been leveled and calibrated.
Use this application to determine the weight of objects in the selected unit of measure.
1. Press
2. Press and hold the
Weighing (this application is the default).
3. Place objects on the pan to display the weight. Once
the reading is stable, the * will appear.
4. The resulting value is displayed in the active unit of
measure.
Item Settings
To view or adjust the current settings.
•
display when the balance is set to zero.
•
•
•
•
Before using any application, be sure the balance has been leveled and calibrated. The minimum piece
weight should be no less than 0.1d.
Use this application to count samples of uniform weight.
1. Press
2. Press and hold the
Parts Counting appears.
1.800.561.8187
or if necessary to begin.
button to select
When set to On, the capacity bar is displayed in the reference field. The capacity will not
Change the displayed unit. See Section 5.4 for more information.
Change Filtering level. See Section 5.3.2 for more information.
See Section 5.7 for more information.
Change printing settings. See Section 7 for more information.
or if necessary to begin.
www.
button until
.com
button.
information@itm.com