OHAUS PX Series Bedienungsanleitung Seite 19

3. Press the
sample. After completion of the test, press the
button to test a new sample.
1.
Press and hold the
appears. Press
2.
In determining density with the balance, the balance
setup and density determination procedures are basically
the same for a floating solid and a non-floating solid
except for the necessary holder (as shown in the figure)
to be used for density determination.
3.
After completion of the test, press the
button to test a new sample.
Lower the sample down into the liquid until it is fully
submerged.
1. Press and hold the
appears. Press
1.800.561.8187
button to get the density of the
button until Density
to enter the Density Determination.
button until Density
to enter the Density Determination.
www.
Holder for non-floating
solids
information@itm.com
.com
Holder for floating
solids