Parts Counting; Calibration - OHAUS SPx303 Bedienungsanleitung

EN-14

Parts Counting

Two types of counting modes are available, standard or enhanced.
N
1
N
1
N
1
(See page 17 for details)
Exiting the .U.N.I.T. Menu
Use the same procedure as Exiting the .S.E.T.U.P. Menu.

Calibration

Span Calibration
Span calibration uses two calibration points, zero and a specified calibration weight.
Before beginning calibration, make sure the Lock Switch is off. Clear the platform.
NOTE: Value of calibration mass depends on capacity of balance . After calibration, the
balance returns to the currently selected weigh mode.
Start with the balance OFF.
5
• • •
Y
1
OR
(Release button)
(Acquiring zero value)
Y
1
N
1
Y
1
(Place mass value on platform)
SPJ
(Example)