Disassembling The Grinder - Gastroback Design Kaffeemühle Advanced Plus Bedienungsanleitung

IMPORTANT - Take into account that the bean hopper may need some hours for
getting completely dry after cleaning. However, for correct operation, it is crucial
that the bean hopper is completely dry. We recommend to clean the appliance at
the end of the day and, after wiping dry, leave the parts dry naturally over-night.
NOTE
You should empty and clean the bean hopper regularly to avoid that stale residues
of coffee beans accumulate within the bean hopper and grinder. This is crucial,
if you wish to prepare the appliance for several days without usage (e.g. during
holidays).

DISASSEMBLING THE GRINDER

NOTE
The bean hopper base is closed automatically, when unlocking the bean hopper.
Therefore, remaining coffee beans will not fall out, when removing the bean hopper.
1. Unplug the appliance. If required, remove the portafilter cradle.
2. Remove the hopper lid. Turn the black lock dial in the centre of the bean hopper
counter-clockwise, until the lock of the bean hopper is released tangibly (approx.
90°). Then, pull the bean hopper upwards, thus enabling free access to the grin-
ding burrs.
3. If there are any coffee beans left in the bean hopper, empty the bean hopper
completely. Thereafter, replace the bean hopper and turn the lock dial back to
the closed position. Replace the hopper lid. Position the storage container in the
grinder cavity.
4. Plug in the appliance and leave the appliance operate, until all remaining coffee
beans are ground. Unplug the appliance and remove the bean hopper again,
as described in step 2.
CAUTION
unlock the grinding sleeve. In this case, grasp the wire handle at both sides just
above the rim of the grinding sleeve. Avoid bending the wire handle. Otherwise,
the wire handle may no longer fit into the groove at the rim of the grinding sleeve,
making it impossible to re-assemble the bean hopper.
5. Pull up the wire handle at the rim of the grinding sleeve. For unlocking the grin-
ding sleeve, via the wire handle, turn the grinding sleeve counter-clockwise.
Then, pull the grinding sleeve out.
EN
50
– There may be some harsh resistance, when attempting to