Setting The Amount - Gastroback Design Kaffeemühle Advanced Plus Bedienungsanleitung

The values given in the following table are approximations meant for guidance. Your
preferred setting may vary according to your individual liking.
Setting Result
1 - 3 Extra fine
4 - 7 Fine to medium
8 - 16 Medium coarse to
extra coarse
IMPORTANT - Whenever possible, set the grind size, before filling the bean hop-
per. Especially, if you wish to set a finer grind size (smaller numbers) with coffee
beans being in the grinder already, always let the motor run, while setting the
grind size. Otherwise, coffee beans may get caught between the grinding tools
and block the motor (see: 'Operation / Removing Blockages').
There are 16 possible settings that can be selected via the grind size dial at the
right side of the grinder head. Your setting will be active, until you change it again.
For setting the grind size with coffee beans in the grinding chamber, start the grin-
der and turn the grind size dial slowly to the desired number (see: 'Grinding into the
Storage Container').

SETTING THE AMOUNT

The grind time determines the amount of coffee powder given off. You may set the
required grind time for getting the desired amount for your preferred brewing method
and amount of brewed coffee. The setting is kept until you change it again.
NOTE
Setting the grind time is effective only for grinding into the storage container.
When grinding into a portafilter, the grinder is started and stopped via the porta-
filter (see: 'Grinding into a Portafilter').
The grind time can be set between 0 (off) and 50 seconds. When using a drip cof-
fee maker, any amount from 2 to 10 cups can be ground in a single grinding cycle.
Use it for ...
Espresso or Turkish coffee
Automatic coffee makers
Pour-over, plunger coffee makers and French press, or cold brew coffee
EN
43