Gastroback Design Kaffeemühle Advanced Plus Bedienungsanleitung Seite 48

Problem
The storage container does
not fit in the grinder cavity.
Ground coffee spills from
the storage container.
The usual amount is not
given off, and/or the
grinder makes an unusual
noise.
EN
48
Mögliche Ursache
Using the storage contai-
ner: The grind time is set
to "0".
Filling a portafilter: The
portafilter cradle is missing
or not installed correctly.
Filling a portafilter: The
portafilter is not installed
correctly.
A severe problem occur-
red.
The storage container is in
wrong orientation.
A portafilter cradle is
installed.
The latch at the container
lid is still closed.
The powder tray is missing. Always install the powder tray, when grinding into the
The storage container is
overfilled.
Electrostatic charge may
be the cause, especially,
when a very fine grind
size is selected.
You changed the grind
size.
Not enough coffee beans
in the bean hopper.
Die einfache Lösung
For grinding into the storage container, you must set a
sufficient grind time.
Slide the portafilter cradle into the runners directly below
the grinder outlet and push the portafilter cradle to the
rear wall of the grinder cavity to the stop.
Below the portafilter cradle, push the portafilter into
the grinder cavity until the grinder starts.
Get in contact with an authorized service centre for exa-
mination and repair.
When inserting the storage container, the filling hole in the
container lid must face to the rear wall of the grinder cavity.
Remove the portafilter cradle. Then try again.
Open the black latch and turn it to the well in the contai-
ner lid. Then try again.
storage container.
Before operation, always ensure that there is sufficient
free space left in the storage container. The build-up of
heaps in the storage container may cause overflow, even
when the container is not filled completely. We recom-
mend to empty the storage container completely, before
grinding another portion.
This problem may occur with inclement weather and fine
grind size. The problem may be reduced, when wiping the
exterior of the storage container via a slightly damp cloth.
Avoid wiping the collection container via any dry cloth made
of synthetics. For cleaning, prefer a cloth made of linen.
After changing the grind size, it may be necessary to
adapt the grind time accordingly (see: 'Operation / Set-
ting the Amount').
Fill the bean hopper.