Properties Of Your New Coffee Grinder - Gastroback Design Kaffeemühle Advanced Plus Bedienungsanleitung

PROPERTIES OF YOUR NEW COFFEE GRINDER

• The DESIGN COFFEE GRINDER ADVANCED PLUS is perfectly suited for grin-
ding fresh, whole coffee beans just before the brewing cycle. Simply adjust the
grind size to the type of brewing method, you prefer.
• The machine meets the high standards set by the »Speciality Coffee Association
of America« and the »European Coffee Brewing Centre«.
• You may fill up to 350 g coffee beans into the bean hopper.
• The locking system of the bean hopper automatically closes the base of the bean
hopper, avoiding that remaining coffee beans fall out, when removing the bean
hopper.
• The stainless steel grinding tools are designed for minimizing the grinding heat.
Therefore, the essential oils and flavours in the coffee beans are protected during
grinding.
• 16 precise grind size settings can be selected via the grind size dial: from
the finest grind for espresso machines to the coarsest grind for plunger coffee
makers.
• Via setting the grind time, the grinder substitutes the repeated usage of a measu-
ring spoon by giving off the correct dose automatically. The appliance comes
with a special storage container for max. 240 g coffee powder. This container
is perfectly suited for operation with the appliance. In the container lid, the ope-
ning for grinding the coffee powder directly into the container is adapted to the
powder outlet of the machine. For grinding, fold back the latch of the container
lid. For storage, the latch may be used for closing the filling hole.
• 2 portafilter cradles sized for 50 - 54 mm and 58 mm portafilters are provided
for directly grinding into the portafilter of your espresso machine. The handling is
as easy as could be: simply push the prepared and pre-warmed portafilter into
the grinder cavity below the portafilter cradle for starting operation. The grinder
stops immediately, when withdrawing the portafilter. To avoid severe injuries
and damage, the safety interlocks of the appliance ensure that the motor can-
not be started, when the grinder is not assembled correctly and completely. If
the bean hopper or the storage container / portafilter cradle is not properly in
place, the grinder will not operate.
WARNING
does not work, refer to the hints given in chapter 'Solving Problems' and clear
away the obstacle. Do not remove any parts, while the appliance is connected to
the power supply.
EN
40
– Do not attempt to corrupt the safety interlocks. If the grinder