Parkside PDTS 6.3 A2 Bedienungs- Und Sicherheitshinweise Seite 70

Safety instructions for pneumatic tools
Hold the machine correctly:
„
Be prepared to counteract the
usual or sudden movements –
keep both hands ready.
Make sure that your body is
„
balanced and that you are
standing on a stable surface.
Activate a startup or shutdown
„
control device in the event of
power outage.
Use only those lubricants
„
recommended by the manufac-
turer.
Goggles must be worn; gloves
„
and protective clothing are
recommended.
A hard hat must be worn for
„
overhead work.
Specify the runout time when
„
this is longer than 5 s; it is
recommended urgently to
place the pneumatic angle
grinder in a protected place.
For abrasive cutting work, the
„
workpiece must be supported
in such a manner that the part-
ing slit maintains a constant
or increasing width during the
whole work.
If the parting disc jams in a
„
parting slit, the pneumatic angle
grinder must be switched OFF
and the parting disc loosened.
Before resuming operation,
check that the parting disc has
been secured properly and is
70 GB/MT
not damaged.
Grinding and parting discs
„
may not be used for face
grinding (exception: face
grinding wheels). Pneumatic
angle grinders may not be
used at circumferential speeds
greater than the maximum val-
ue specified for an abrasive.
The operating personnel must
„
make sure that there is nobody
standing nearby.
Personal protective equip-
„
ment such as suitable gloves,
aprons, and hard hats must be
used.
The sparks generated by
„
parting work may ignite cloth-
ing and cause serious burns.
Make sure that the sparks do
not contact clothing. Wear fire
retardant clothing, and make
sure that there is a pail of wa-
ter nearby.
HAZARDS FROM REPEATED
MOVEMENTS
Using a pneumatic angle
„
grinder for work related ac-
tivities may cause unpleasant
sensations in the operating
personnel's hands, arms, neck,
shoulders, and other parts of
the body.
When using a pneumatic
„
angle grinder, the operating