Cleaning, Maintenance And Repairs; Preparing Trimmer For Operation - Stihl FSA 90 Gebrauchsanleitung

English
► Store the battery separately from the trimmer and
charger.
► Store the battery in non-conductive packaging.
► Use and store the battery at temperatures between -
10°C and +50°C.

4.11 Cleaning, Maintenance and Repairs

WARNING
￭ The trimmer may start unintentionally if the battery is left
in place during cleaning, maintenance or repair
operations. This can result in serious injuries and damage
to property.
► Push the retaining latch into position
► Remove the battery.
￭ Aggressive cleaning agents, a water jet or pointed objects
can damage the trimmer, deflector, cutting attachment
and the battery. If the trimmer, deflector, cutting
attachment or battery are not cleaned correctly,
components may no longer function properly or safety
devices may be rendered inoperative. This can result in
serious injuries.
► Clean the trimmer, deflector, cutting attachment and
battery as described in this instruction manual.
￭ If the trimmer, deflector, cutting attachment or battery are
not serviced or repaired correctly, components may no
longer function properly or safety devices may be
rendered inoperative. This can result in serious or fatal
injuries.
► Do not attempt to service or repair the trimmer,
deflector, cutting attachment or battery.
► If the trimmer, deflector, cutting attachment or battery
require servicing or repairs: Contact your STIHL
servicing dealer for assistance.
50
► Maintain the cutting attachment as described in the
instructions supplied with the cutting attachment being
used or on the cutting attachment's packaging.

5 Preparing Trimmer for Operation

5.1
Perform the following steps before starting work:
► Make sure the following components are in a safe
condition:
– Trimmer, @ 4.6.1.
.
– Deflector, @ 4.6.2.
– Mowing head or metal cutting attachment, @ 4.6.3 or
@ 4.6.4.
– Battery, @ 4.6.5.
► Check the battery, @ 11.2.
► Recharge the battery fully as described in the instruction
manual for the STIHL AL 101, 300, 500 chargers.
► Clean the trimmer, @ 16.1.
► Mount the handle, @ 7.1.
► Select combination of cutting attachment, deflector and
carrying system, @ 21.
► Mount the deflector, @ 7.3.1.
► If a metal cutting attachment is used on a loop-handled
trimmer: Mount the barrier bar, @ 7.2.
► Mount mowing head or metal cutting attachment, @ 7.4.1
or @ 7.5.1.
► Fit and adjust the carrying system, @ 8.1.
► Balance the trimmer, @ 8.2.
► Adjust the handle, @ 8.3.
► Check the controls, @ 11.1.
► If 3 LEDs flash red while you are checking the controls:
Remove the battery and contact your STIHL dealer for
assistance.
There is a malfunction in the trimmer.
5 Preparing Trimmer for Operation
Preparing Trimmer for Operation
0458-709-9821-B