Correct Use; Safety Instructions; Work Capacity - Gesipa TAURUS 1 Speed Rivet Betriebsanleitung Mit Ersatzteilliste

1.

Correct use

The rivet setting tool is designed exclusively for setting speed rivets as described in the
operating instructions.
Please observe the safety instructions!
2.

Safety instructions

• The rivet setting tool should only be used for setting speed rivets.
• Do not overload the tool; work within the prescribed work capacity.
• Do not use the tool outside of riveting holes. The speed rivet could be ejected from the tool!
Never turn the tool towards yourself or towards other people.
• Protective tube and protective cover should always be fitted when operating the setting
tool.
• Do not use the rivet setting tool as a hammer.
• Check compressed air connections regularly to ensure they are well-fitted and airtight.
• When carrying out maintenance work on the rivet setting tool and when the tool is not in
use, it should always be disconnected from the compressed air network.
• When working with the tool, always wear protective goggles. Personal protection like
clothes, gloves, safety helmet, non-slip shoes, ear protection and anti-fall protection are
highly recommended.
• Do not exceed the permitted working pressure.
• When depositing the rivet setting tool, make sure that it cannot fall.
• Repair work must be carried out by skilled personnel. In case of doubt, always send the
complete rivet setting tool back to the supplier or to GESIPA
• Dispose of the used hydraulic oil in accordance with valid environmental protection regu-
lations.
3.

Work capacity

Tool type
Standard speed rivet (mm)
All materials
Exceptions
TAURUS 1 Speed Rivet
®
2,4 - 4,8
up to 4.0 stainless steel
.
®
TAURUS 2 Speed Rivet
®
2,4 - 6,4
21