8.2
Refilling hydraulic oil
•
Disconnect the setting tool from the compressed air network.
•
Unscrew oil refill screw using Torx screwdriver T20 and at the same time remove the
seal.
•
Insert the supplied oil press into the oil refill container.
Caution!
Push the oil press in as far as the buffer, otherwise the oil will be discharged
without any control.
•
Unscrew supplied oil refill container.
•
Connect the rivet setting tool to the compressed air network and activate the trigger; then
disconnect the rivet setting tool from the compressed air network.
•
Unscrew the oil refill container with oil press and remove the old oil from the oil refill
container.
•
Screw up the oil refill container tight by hand and fill up to the mark with hydraulic oil.
•
Insert the oil press into the oil refill container and push in until it can't go any further or
there is no more oil in the oil refill container.
•
Connect the riveting tool to the compressed air supply.
•
The riveting tool vents automatically and excess oil is transferred back into the oil refill
container.
•
Unscrew the oil refill container with oil press. Remove any remaining oil from the rivet
setting tool.
•
Insert the seal and screw in tight the oil refill screw using Torx screwdriver T20.
Regular maintenance will extend the service life of your high-quality GESIPA
they should be serviced at least every 2 years by an authorised workshop or by GESIPA
Service. For tools that are used intensively, we recommend servicing ahead of schedule.
8.3
Storage
The setting tool should be stored in a dry place where there is no danger of frost.
30
tools and
®
®