Gesipa TAURUS 1 Speed Rivet Betriebsanleitung Mit Ersatzteilliste Seite 28

• Insert speed rivet with mandrel spring into the spreader nosepiece.
• With the spreader nosepiece open, insert the speed rivet with mandrel spring
so that only one speed rivet protrudes.
• Turn the knurled ring to the right or left again to close the spreader nosepiece.
7.4.3 Spreader nosepiece with/without opening mechanism
• With the spreader nosepiece closed, the speed rivet must protrude by a defined distance
• Activate the white valve in order to ensure the rivet setting tool is ready for operation.
• Use the rivet setting tool to insert the speed rivet into the riveting hole as far as the buffer.
• Activate the trigger until the setting process is complete.
• Remove the rivet setting tool from the riveting point.
• Release the trigger.
• Wait until the next speed rivet has been reloaded.
28
1.5mm-3mm
1.5mm-3mm
0.13 24.01.13 - Kolle J. -
Rev.: Datum Aenderung: gezeichnet geprueft
Zeichnung wurde mit CAD erstellt
Massstab Werkstoff
Datum Name
-
Bearb. 24.01.13 J. Kolle
1:1
Maße ohne Toleranzangabe
Gepr. - H. Harder
Zeichnung ins PDM-System eingep
Text
Schutzvermerk DIN ISO 160
0.1
Halbzeug
Rev
-
Oberflaechenangaben nach