Blind Rivet Setting Tool; Intended Use; Safety Instructions; Working Range - Gesipa AccuBird Betriebsanleitung

GB
1.

Blind rivet setting tool

1.1

Intended use

As described in these operating instructions, the riveting tool may only be used for the purpose
of setting blind rivets.
Observe the safety information!
1.2

Safety instructions

Caution!
The following safety rules must be observed to ensure adequate protection against electric
shocks, injuries or fire hazards:
• The riveting tool is intended solely for the purpose of processing blind rivets.
• Never overload the tool; work within the specified working capacity.
• Never use the riveting tool in a humid or wet environment or close to flammable liquids or
gases. Danger of explosion!
• Ensure that the battery is properly secured in the handle.
• Always remove the battery when the riveting tool is not in use and for maintenance.
• Never use the riveting tool as a hammer.
• When not in use, keep the riveting tool in a dry, closed room and out of the reach of children.
• Always wear protective goggles when working with the riveting tool. Personal protective
equipment such as protective clothing, gloves, safety helmet, non-slip footwear, ear
protection and fall arresting device is recommended.
• The air inlets for the motor should not be obstructed; do not insert any objects into them.
• When putting down the riveting tool, make sure that it cannot fall.
• Use only genuine spare parts for repairs.
• Repairs must be carried out only by skilled personnel. In case of doubt, always send in the
riveting tool to the manufacturer.
• Do not use tool without material! The blind rivet could be flung from the riveting tool! Never
turn the riveting tool towards yourself or towards another person!
• The spent mandrel container (No. 31) must remain mounted on the riveting tool during oper-
ation.
1.3

Working range

For blind rivets up to Ø 5 mm in all materials. BULB-TITE
6.3 mm Ø aluminium and steel.
18
blind rivets 4 mm; 5.2 mm and
®